Please Note: We do our best to ensure all pricing is accurate. However, should there be any errors, we reserve the right to bill the correct price on the invoice.
AFTERMARKET FORD IKT KEYS – PROGRAMMING INSTRUCTIONS
The
aftermarket IKT keys require a 2-step programming procedure. Step 1 will program the transponder chip and
Step 2 will program the remote functions.
Step 1 à Programming the TRANSPONDER CHIP
Use
programming equipment as usual, then continue to Step 2 or, if programming “on
board”, do as follows:
To add a Duplicate Key (requires 2 working keys):
1.Insert the first original key and
turn the ignition from the OFF position to the ON position for at least 3
seconds but no more than 10 seconds.
2.Turn the ignition to the OFF
position and within 10 seconds, remove the first original key and insert the
second original key. Turn the ignition from the OFF position to the ON position
for at least 3 seconds but no more than 10 seconds.
3.Turn the ignition to the OFF
position, remove the second original key and within 20 seconds insert the new,
unprogrammed key. Turn the ignition from the OFF position to the ON position
for at least 6 seconds and then remove the key.
4.The theft indicator light will
light up for 3 seconds and then go out to indicate the key has been programmed.
The key should start the vehicle. To add
more keys, wait 20 seconds and repeat from Step 1.
Step 2 à Programming
the REMOTE
- 1.Using the key with the remote that you are
programming, turn the ignition from OFF to RUN 4-times within 3 seconds, with
the 4
th time ending in the RUN position.
- 2.Door locks will cycle to confirm in Programming
Mode.
- 3.Within 20 seconds, press any button on the
remote. Door locks will cycle to confirm
programming.
- 4.If programming a second key, within 20 seconds,
press any button on the 2
nd remote.
Door locks will cycle to confirm programming à skip this step if only programming one remote.
- 5.Turn
ignition to OFF. The door locks will
again cycle to indicate end of programming mode.