Please Note: We do our best to ensure all pricing is accurate. However, should there be any errors, we reserve the right to bill the correct price on the invoice.
AFTERMARKET FORD IKT KEYS – PROGRAMMING INSTRUCTIONS
aftermarket IKT keys require a 2-step programming procedure. Step 1 will program the transponder chip and
Step 2 will program the remote functions.
Step 1 à Programming the TRANSPONDER CHIP
programming equipment as usual, then continue to Step 2 or, if programming “on
board”, do as follows:
To add a Duplicate Key (requires 2 working keys):
1.Insert the first original key and
turn the ignition from the OFF position to the ON position for at least 3
seconds but no more than 10 seconds.
2.Turn the ignition to the OFF
position and within 10 seconds, remove the first original key and insert the
second original key. Turn the ignition from the OFF position to the ON position
for at least 3 seconds but no more than 10 seconds.
3.Turn the ignition to the OFF
position, remove the second original key and within 20 seconds insert the new,
unprogrammed key. Turn the ignition from the OFF position to the ON position
for at least 6 seconds and then remove the key.
4.The theft indicator light will
light up for 3 seconds and then go out to indicate the key has been programmed.
The key should start the vehicle. To add
more keys, wait 20 seconds and repeat from Step 1.
Step 2 à Programming
- 1.Using the key with the remote that you are
programming, turn the ignition from OFF to RUN 4-times within 3 seconds, with
the 4th time ending in the RUN position.
- 2.Door locks will cycle to confirm in Programming
- 3.Within 20 seconds, press any button on the
remote. Door locks will cycle to confirm
- 4.If programming a second key, within 20 seconds,
press any button on the 2nd remote.
Door locks will cycle to confirm programming à skip this step if only programming one remote.
ignition to OFF. The door locks will
again cycle to indicate end of programming mode.